When installing bearings, the most important thing is to keep bearings and related parts clean and use installation tools and methods correctly. Therefore, be sure to observe the following precautions:

1. Clean up the working area and use clean tools or auxiliary tools.

2, the installation should use good plastic is not easy to fall off the auxiliary tools.

3. Confirm that all assembled parts are qualified.

4. Bearings can only be unsealed when they are in use.

5, the operation should keep the bearing clean.

6. Under normal circumstances, anti-rust oil does not have to be washed away. It can be installed in accordance with the original state.

Second, the installation of bearings – check work before installation

1. Are the dimensions of the shaft and bearing body processed according to the requirements of the drawings? Are the corners and right angles of the shaft and bearing body convex? Can they be in full contact with the end face of the bearing? All must be thoroughly examined.

2, should determine whether the shaft, bearing body of the mating surface collision, protrusion, etc.. Whether there is dust or mold sand attached to the surface of the bearing housing. If there is to oil grindstone, fine sandpaper or clean cloth, etc.

3. In order to avoid collision during installation, a small amount of lubricating oil should be applied to the working surface of the shaft and bearing body.

If you have any questions,pls feel free to contact us.

e-mail:bearing6@hyzcgroup.com